Lizard skin stick grips

[Dbb135]

The 3d file can be downloaded from my Thingiverse page: https://www.thingiverse.com/thing:3783281

Post a 'Make' if you print them! If there is enough interest I can put together a 'kit' and make them available (3d printed parts, pushbuttons, connectors, grips...).

[mike92104]

The 3d file can be downloaded from my Thingiverse page: https://www.thingiverse.com/thing:3783281

Post a 'Make' if you print them! If there is enough interest I can put together a 'kit' and make them available (3d printed parts, pushbuttons, connectors, grips...).

I'd be interested in a "kit".

[Dbb135]

I'd be interested in a "kit".

I'll put together a kit with instructions. The kit will include the following:

2 switches
2 switch connectors with pigtail
2 JST Male connectors with pigtail
2 JST Female connectors with pigtail
2 3d printed switch adapter fittings

Grips will need to be purchased that have two locking grips, I recommend LizardSkin Shortys, but you choose what you like and what will fit your Kitfox.

I think $30 + shipping is fair. Send me a private message if interested.

Also, I am fairly new to the group, so if selling items on the forum is frowned upon, please let me know.

[DesertFox4]

Also, I am fairly new to the group, so if selling items on the forum is frowned upon, please let me know.

As you are new, the short answer is no you can not advertise and sell products on TeamKitfox.com unless you are a paid sponsor like all the good folks at the top of every page are.

Now, everyone that saw your post and can figure out how to email you behind the scenes (do not post your email in the thread) might contact you that way if they could use your kit.

Do not use TeamKitfox's Private Messaging feature for contacting the poster about this kit. Private messaging impacts my costs for service ever so slightly but emailing does not.

[mike92104]

Installed minus wiring.

[Hawkertech]

Did you have to sand the adapter or grip to make then fit? It look like I need to sand some off the adapters.

[Dbb135]

They should slide right into the grip locking rings. Note that they do not go into the control stick tube. There may be a slight edge on the bottom that could be sanded if needed, but nothing too aggressive should be required. Send some pics and maybe I can assist further.


Sent from my iPhone using Tapatalk