In the process of working on a new spinner my condition inspection became due. I pulled the center console side panels off to inspect and was surprised to find as much pieces of junk in there. I thought I was thorough in building it keeping shavings vacuumed up but there was quite a few metal shavings. Took a vacuum and cleaned out the metal shavings and a lot of dirt. Compression was perfect, plugs looked good and exhaust welds looked good. When I put updated exhaust to the new version, the fitment wasn't great. The exhaust is for the Edge Gen II engines which are slightly different because of new turbo, so I needed to extent the exhaust slightly.