I'm just trying to plan out some electrical and wondering if anyone knows the current draw on the trim position sensor and the low fuel sensor that you can get from kitfox directly.
I'm just trying to plan out some electrical and wondering if anyone knows the current draw on the trim position sensor and the low fuel sensor that you can get from kitfox directly.
912 IS
Airmaster Prop
Garmin Stack
C-FKLO
Not sure of the actual draw but I have a 7.5A breaker for the trim
------------------
Josh Esser
Flying SS7
Rotax 914iS
AirMaster Prop
Edmonton, AB, CWL3
I believe those two sensors only draw milliamps.
Jim Ott
Portland, OR
Kitfox SS7 flying
Rotax 912ULS
That is correct, these sensors are negligible as far as their current draw. The current for sensors connected to the GEA-24 is included in the current of the unit. In table 2-2 of the G3X Installation Manual it says a 12 volt GEA-24 has 0.43 Amps max with typical sensor loading.
Phil Nelson
A&P-IA, Maintenance Instructor
KF 5 Outback, Cont. IO-240
Flying since 2016