-
Senior Member
Wing Root Cuffs
Would anyone be willing to share some photos of the under side of their wing root cuffs. I'm currently making them out of Laker Leading Edge material, but I'm having a hard time not leaving an open gap between the top of the door and the fairing.
In this picture, you can see that the LLE material does not extend back far enough. I've already extended the fiberglass rearward. That's not that gap I'm talking about. I've tried to draw what I'm talking about in blue. I'm wondering if when these are made in aluminum, this gap is covered because the aluminum would not follow the wing contour as closely. I'd like to see how the Al ones fit so I can know if this is feasible with the LLE material.
Last edited by aviator79; 01-28-2019 at 03:56 PM.
--Brian
Flying - S7SS
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules