I was working on fitting my lift strut speed fairing yesterday and had the wings back on the fuselage to locate the holes for the jury strut attach points in the fairing. I rigged the jury struts by the measurements I took after installing them. Everything looked good so I went on and attached the fairings. Then I noticed that one of the fairing trailing edges doesn't quite look perfectly straight. Im not sure if the center of the plastic fairing sagged slightly as the hysol dried or if the lift strut is slightly bend in the middle, but the trailing edge it is out of perfectly straight by a little under a 1/4 in. Now Im concerned somehow my jury struts might be out of perfect alignment. To be safe I wanted to get your opinion on whether a 1/4 inch out of straight could be problematic, from a structural standpoint. Im likely overthinking it, but I want to be sure.

Thanks