I hung my wings (not yet covered) up from some hooks in the ceiling a few weeks ago to start working on the fuselage and today I noticed as I looked down the two wings hanging side by side that my plastic leading edges are not at the identical angle. It's not much difference but I did notice it, I guess I did not have the template pushed hard enough on the one wing to set the leading edge. Question is, is this going to make a difference in performance? I can live with it as is, not sure others will even notice it. If I were wanting or do need to remove it and set a new one I may be concerned about getting it off without damaging the spar. Any advice here would be great.