Batteling Fish Eye

[DanB]

I wish I could say that I was on a boat off a tropical coastline doing some blue water fishing, however, that's not it.
I'm spraying my second wing at the Poly Spray stage. I got quite a bit of fisheye going on so I stopped and let the coat that I sprayed down dry for several hours. I went back and did some wet sanding with 400 grit over the affected areas...wiped it dry then hit the whole wing again with 2210 solvent. (I'm religious using this between coats).
After the solvent dried I went to spraying again...same thing...I was getting fisheye in exactly the same spots that I sanded and cleaned.
So...Who knows some tricks? I'm about ready to roll over and play dead.