I've been looking at past postings on various drag reducing fairings but never came across one that would streamline the rectangular cross section of the grove gear under the fuselage. I bent a sheet of .060" thick lexan and shaped it to fit around the gear seen in the attached photos. The lexan is light, strong and flexible so I'm trying it out but I honestly don't expect a measurable improvement in airspeed. I miss the building phase and needed a project to keep from getting bored. I also put a fairing that came with my kit behind each gas cap. I shaped the bottom edges of these small fairings to conform to the curve of wing, pressed it into some of the light foam that came with my kit and glued it down to the wing with silicon RTV. I held it in place while the RTV set up using a small C clamp.
IMG_9429.jpgIMG_9427.jpg