Hello,

I'm installing the rudder and vertical stabilizer ribs and there are 4 places where the ribs are bonded to the tubes.
The issue is that while bonding the ribs to the tubes, some of them (all except one) are not on the same line.
The top ribs are not on the same line because the rudder tube is thinner than the vertical stabilizer tube (left picture).
The second tubes from the top are on the same line, but the two bottom ones are not (right picture).

IMG_0384.jpgIMG_0383.jpg
Any recommendations to make them on the same line or should I go ahead and bond them to the tubes?

Thanks,
Motti