In Section B, Page 5 of the manual, Flight Controls Installation, it shows one type of washer on the left stick pivot and a different one on the other. See the attached picture.
manual error 1.png
On the right pivot, it uses the "N" callout washers to hold the rod end bearing, and the "M" callout washer for the bolt. On the left pivot, it calls out the "M" washer to hold the bearing and the "N" washer for the bolt. The thinner "N" washers slipped in easily on the right, but the thick "M" washers were a bit of a pry and force to get both in.

It look like to me the thin washers should be used on both sides for the bearing, and the thick washers used for the bolts.

Anyone else question this? Anyone go ahead and do what I'm suggesting?