Good Morning all.

Was wondering if anyone here recently got a kit to compare to spar parts I got recently.

I'm replacing the spars on my kit (dont ask, long story ) and just got my new spars in with my firewall forward.

First off - the crating was very impressive. The long crate was stiff as could be, no shipping damage, and the parts were nicely separated inside the crate with special foam with zero wiggle room or moving parts.

Unfortunately during my inspection I found gouges on each spar that are beyond able to be buffed out. I would guess some as deep as .008.

After I inspected the tubes, I looked at the I-beam I inserts and noticed each has a deep indentation running lengthwise. It is deep enough to grab a fingernail and not slip - Maybe .015 or more. It looks to me like a blemish in the extrusion process but I could be wrong?

I just wanted to get some opinions here. Has anyone else seen stuff like this? Am I being over critical? Screenshot_20200202-114754_Photos.jpgScreenshot_20200202-114804_Photos.jpgScreenshot_20200202-114748_Photos.jpgScreenshot_20200202-114906_Photos.jpgScreenshot_20200202-114731_Photos.jpg