Hi everyone,

Was wondering if anyone might have some field application photos they can share for the G3X, "Sub-assembly, external component kit for Rotax 912 rpm, and oil pressure senders.

Garmin PT#(K00-00514-00 G3X engine Sensor Kit, Rotax 912)

I called tech support and they were very helpful as to where they are identified in the install manual, but not how to field install behind the unit. See page 486 in the manual, see note 12.

I'd like to learn how to best install per the application, including how to test polarity, or face the silicon/zener diodes, and resistor, the proper direction per the pin references on the manual.

Any information on how to, or pics of the install is greatly appreciated!

Thank you!