-
Senior Member
Long Reach Tinnerman nuts
Some (most) of the holes on my tail access cover are a bit too far from the edge to get the factory ones on. For sure my mistake and should have looked at them before drilling. So now Ive been trying to find some longer reach #4 tinnerman plates or other solution. I got some of the flat type nut plates and was thinking I could hysol/glue them to the side but Im not convinced the fabric that is wrapped around the angle will hold. Any ideas?
Thanks!
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules