-
Re: jf build
one thing i found hard to do...it's holding the stiffener on rib's....i find a little tip ...it's very easy like that with electric wire holder...
100_0887.jpg
and i start to mount my rudder...the project continue..
100_0879.jpg
Last edited by Jfquebec; 05-28-2013 at 12:19 PM.
-
Re: jf build
100_0988.jpg
finish for that.....we can go for the next job...
100_0971.jpg
i install all reinforcement for flaperon bracket....
-
Re: jf build
-
Re: jf build
100_0974.jpg
and for the second time ,i install my two wingtank ...i put one tube of dow corning silicone on each tank and the result was very good....the tank dosen't touch the front and rear spar...thats what i want.....
-
Senior Member
Re: jf build
JF,
Not only did the silicon work out well.......from your photo it looks like you had a really good level fit between the top of the tank and the top of the ribs on either side of the tank
Dave S
KF7 Trigear
912ULS WarpDrive
St Paul, Mn
-
Senior Member
Re: jf build
Looking good JF. Maybe in a couple years we can meet up at Oshkosh. It's close enough to half way.
-
Re: jf build
Thank's Dave...it's only look like on pic,because is a little bit more higher..but it's not bad.......
And yes Josh...Oshkosh it's more close...
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules