jf build

[Jfquebec]

100_0988.jpg

finish for that.....we can go for the next job...


100_0971.jpg

i install all reinforcement for flaperon bracket....

[Jfquebec]

100_0961.jpg

my fuel gage...


100_0962.jpg

[Jfquebec]

100_0974.jpg

and for the second time ,i install my two wingtank ...i put one tube of dow corning silicone on each tank and the result was very good....the tank dosen't touch the front and rear spar...thats what i want.....

[Dave S]

JF,

Not only did the silicon work out well.......from your photo it looks like you had a really good level fit between the top of the tank and the top of the ribs on either side of the tank


Dave S
KF7 Trigear
912ULS WarpDrive

St Paul, Mn

[Esser]

Looking good JF. Maybe in a couple years we can meet up at Oshkosh. It's close enough to half way.

[Jfquebec]

Thank's Dave...it's only look like on pic,because is a little bit more higher..but it's not bad.......
And yes Josh...Oshkosh it's more close...

[Jfquebec]

hi guy's there is my progress...i install the leading edge..4 hour per piece...
but good result..the only thing is the overflow of glue each side of LE...some place along the spar are a little bit rought...ans i dont want take chance to sand the aluminum spar...if you are any suggestion let me know...

Attachment 6035

100_1032.jpg

[Jfquebec]

i let the LE flush with wing tip and 1 inch out to the other side ..

100_1033.jpg

[Jfquebec]

and i starting to install the wing tip attach ...i dont cut the aluminum bar i just trim it..

.100_1028.jpg

[Jfquebec]

and install the wood part who hold the sky light...

[ATTACH]100_1060.jpg[/ATTACH]


after that my friend Dave give me a hand to remove the wing down ...and i starting to make 4 wing rotator..

100_1057.jpg

next i will install the false rib under the fuel tank...