I updated some pictures in my albums today. The latest accomplishments are as follows:
Advanced Flight Systems - AOA ports installed on the top and bottom of the wing.
http://www.teamkitfox.com/Forums/alb...pictureid=3790
AFS - AHRS mounting plate installed in the wing. I had to adjust this plate to level flight for it to work correctly.
http://www.teamkitfox.com/Forums/alb...pictureid=3793
http://www.teamkitfox.com/Forums/alb...pictureid=3792
Outside Temp probe (OAT) mounted in the wing where the Pitot normaly goes.
I ran the wiring for the Pitot, OAT and AHRS through a piece of tubing between the rear spar and the aft end of the fuel tank. The AOA and wing tip/landing light wiring will be run through the rear spar.
I mounted the Petot tube 1 bay inboard so it would be protected by the struts. Like DesertFox4 did in this post (http://www.teamkitfox.com/Forums/album.php?albumid=298) Thanks DesertFox4 for the tip.
Finally started in on the Polyfiber. I have never done or seen this process before. I had read the book and talked to people about it but I still didn't know exactly what to expect. Good thing I could depend on help from Kitfox the Polyfiber manual and the internet.
http://www.teamkitfox.com/Forums/alb...pictureid=3799
Here is a picture of the wing heated to 250 deg.
http://www.teamkitfox.com/Forums/alb...pictureid=3801
Next I plan on finishing up this wing, then onto the second wing followed by the fuselage.
Thanks
Scott