Don't forget the mixing tips. they are not included with the barrel.
Eddie
Don't forget the mixing tips. they are not included with the barrel.
Eddie
I thought I could get by without the gun, but trying to push the two plungers thru the mixing tip with my thumb proved almost impossible.
Jim Ott
Portland, OR
Kitfox SS7 flying
Rotax 912ULS
What I really liked was the fact that when you stopped pulling the trigger, the flow of hysol stopped as well. Put the cap back on and only waist whats in the mixing tip.
Its been a while since I posted so thought I'd get off my butt and contribute.
The LH wing is complete except for instal of the LLE option and fuel tank, and I've started the RH wing. Rudder cables have been swaged for both seat positions (I have dual controls in this) and I'll also be installing turnbuckles. I've made up two access panels for the rear fuselage below the horizontal stab. and these will be located directly adjacent to where the rudder cable turnbuckles will be and will also allow good access to inspect the lower bolt and hardware holding the horizontal stab. trim actuator. All nyloc nuts have been swapped out for castellated nuts on all rotating joints in control systems. I bought Hoerner wing tips for this beast so I've fitted the nav light standoffs and am making my own landing light/wig-wag light instal. So far so good. Some in-process photos are attached. Ignore the ugliness of the wingtip standoff fibreglassing - didn't have a photo of it sanded down ...!
Last edited by David47; 09-04-2017 at 12:48 AM.
David
SS7 Builder
Looking great David. Funny how much room there seems to be under the center console at that stage. It fills up fast. I put the engine mount bolt in yesterday and was quite irritated by the end of it.
Eddie
Hi David,
great progress! And a really neat job too! keep in mind we have our flyin up hear on the 25th November if interested. I'm sure we can arrange some Kitfox time too!
cheers
Ross
Mt Beauty, Vic
OZ
Sold to Richard and Scott Taubman in OZ, 2019. Kitfox SS7,Rotax 912is Sport, Airmaster CSP 75" blades.
Landcruiser and Cub off road camper (doesn't get any kudos on this forum!)
Good progress and nice workmanship David. Like the access panel location.
Am I the only one that thinks an uncovered Kitfox wing is a thing of beauty?
DesertFox4
Admin.
7 Super Sport912 ULS Tri-gear
Not at all Steve. I considered hanging mine from my living room ceiling as Art Deco. It looked so good on the garage ceiling.
Eddie