Turtle build

[dc910sn]

Nice job! Can't wait to get started, I'll be ordering the same color with white trim.

[colospace]

I have relied upon a materials quantity that John Evens worked up which resulted in ~$6300 cost. Pricey, but I was NOT looking forward to building a big enough paint booth in my garage and trying to get sufficient lighting in there to do a good job. I will still of course need to spray the cowl, flaperons, etc., but figure I can do them outside. I have been told that Stewart Systems will be doing a paint match to the Oratex colors, and hope to use that paint. Since my plane is powder coated in white, I will probably be doing a white trim also. I will be investigating vinyl for trim rather than paint. At the turtle pace, I have time to figure that out.

[Kurt.A]

Looking really nice Gary. Hope mine turns out as nice.

[HansLab]

I would OraCover the flapperons as well, if I were you: Nice straight and flat pieces - and you'll be sure of the coulour gliss, lifetime, decoulourisation and so on. And fun to do, as well.

One question though: Steward and Poly (and Kitfox as well) urge you to put reinforcements onto ribs, longerons etc. I don't see that in your first result. Are you still up to that one or is OraCover that strong that you can leave those parts?

[colospace]

Hans,
Reinforcing and edge tapes are used in all the usual places same as PolyFiber, they just aren't showing well in the photo.

[colospace]

Progress! Now have first wing covered.

[jrevens]

That looks great, Gary! If I don't get going you're going to be forging ahead of me! Then mine will be the "Turtle build" - and I'll call you the RED DEVIL!