Kitfox Aircraft Stick and Rudder Stein Air Grove Aircraft TCW Technologies Dynon Avionics AeroLED MGL Avionics Leading Edge Airfoils Desser CPS Parts EarthX Batteries Kitplane Parts
Page 44 of 44 FirstFirst ... 344041424344
Results 431 to 436 of 436

Thread: Dual STI build log

  1. #431
    Senior Member
    Join Date
    Dec 2017
    Location
    Mapleton,UT
    Posts
    512

    Default Re: Dual STI build log

    Curious to see others results with the balance master. We received our second balance master and we put it on our 582 powered parachute. It runs very smooth now!

    I have been on the road, but I am back in town now as I have the next 2 weeks off. Going to get the VG's installed this week and go flight test them.

    N53TF wiring is complete. Just waiting on an Ipad and landing lights and its complete. Programming went smooth and very fast. Because we wired both planes identical programming went very fast, and brain damage on the second STI was minimal. What took me what seemed like a week to program everyting on 33TF took about and hour on 53TF. I learned that you can just export your config file, then import the config file to the other G3X. G3x will not recognize config file unless both G3X versions are the same. It will then copy everything except calibration settings. Makes it very quick to setup. All my limits that I have been programming got transferred over. Cory only really had one mess up that took out the canbus. He had the wiring for the shield incorrect and the ground on the GMU wrong. Garmin is very helpful and he got all the troubleshooting taken care of pretty fast. Plan is to try and make sure the wiring is good by just running avionics a bunch, hoping if anything is going to die, it will die sooner than later. Getting ready for the first engine start and then its getting close. Windshield and doors are done. Turtle deck needs to be finished and flapperons need to be installed. Oh... and Cory needs his tail endorsement.







    Dustin Dickerson

    Building 7ss STI x 2
    Oratex
    29" shock monster
    EP912STI 155hp
    Garmin
    N33TF......FLYING!
    N53TF......Building

  2. #432
    Senior Member
    Join Date
    Dec 2017
    Location
    Mapleton,UT
    Posts
    512

    Default Re: Dual STI build log

    Sorry I thought I had figured out how to embedded a google photo. I will try again.





















    Last edited by Shadowrider; 01-13-2020 at 06:35 AM.
    Dustin Dickerson

    Building 7ss STI x 2
    Oratex
    29" shock monster
    EP912STI 155hp
    Garmin
    N33TF......FLYING!
    N53TF......Building

  3. #433

    Join Date
    Aug 2019
    Location
    Spring Garden Illinois
    Posts
    25

    Default Re: Dual STI build log

    That is a very nice looking wiring job. Can you reach the water that goes to the heater shut off valve from inside the cockpit ?

  4. #434
    Senior Member
    Join Date
    Dec 2017
    Location
    Mapleton,UT
    Posts
    512

    Default Re: Dual STI build log

    Yes. So you can shut it off when itís warm outside.
    Dustin Dickerson

    Building 7ss STI x 2
    Oratex
    29" shock monster
    EP912STI 155hp
    Garmin
    N33TF......FLYING!
    N53TF......Building

  5. #435
    Senior Member
    Join Date
    Dec 2017
    Location
    Mapleton,UT
    Posts
    512

    Default Re: Dual STI build log

    Thought I would post a solution for the tall pilots. I did not want the top of my headset scratching my window. I used some extra Hydro turf from my standup jetskies glued to the top with CA. Its like duct tape, many uses. Its soft enough it wont scratch and weighs almost nothing


    Last edited by Shadowrider; 01-15-2020 at 06:17 PM.
    Dustin Dickerson

    Building 7ss STI x 2
    Oratex
    29" shock monster
    EP912STI 155hp
    Garmin
    N33TF......FLYING!
    N53TF......Building

  6. #436
    Senior Member
    Join Date
    Dec 2017
    Location
    Mapleton,UT
    Posts
    512

    Default Re: Dual STI build log

    VG's are on! It was a little tedious to prep them and paint them. Once you start installing them its not bad and it goes fast. Half tanks of fuel before vgs, I am stalling 47mph power off and 42mph power on full flaps at 8500MSL. WX looks good tomorrow so I am hoping to see how much they help. Hoping for 5mph!














    Dustin Dickerson

    Building 7ss STI x 2
    Oratex
    29" shock monster
    EP912STI 155hp
    Garmin
    N33TF......FLYING!
    N53TF......Building

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •