Finished work on the turtledeck. Not sure why the hardware in the kit was so different than the rest of the windscreen, so a quick call to AC Spruce and I replaced the hardware.
Decided to get the split seals for the flaperon torque tubes. (Thanks Jeff "jmodguy") Turtledeck Slot Seal - Page 2 (teamkitfox.com)
As others have found out, A small precise hole in the turtleback will not allow you to remove it from the aircraft due to the windscreen lip it fits under in front. You need to be able to slide it back to remove it.
IMG_1823.jpg
Finished the dash. Lot's of fun as it need to go in and out countless times. My back was not happy but, in the end, it turned out nice. It ended up at about 1 1/2 inches of overhang.
IMG_1819.jpg IMG_1818.jpg
My taxi cam seemed to like this spot on the lower cowl. It has 170 deg. lens, so it looks good from the cockpit. Used vhb tape to mount it. If it works well there, I'll fasten it down with some proper hardware.
IMG_1816.jpg
Was able to use my airbrush on some parts. It's a simple kit that gets the job done. Was nice to paint without using the paint booth!
IMG_1810.jpg IMG_1811.jpg