What aspects of the larger airframe seats are you looking for?
What aspects of the larger airframe seats are you looking for?
I just got my Oregon aero cushions. Will measure them when I get home this afternoon
Jeff
KF 5
340KF
Seat bottom
17 1/2” long
15 1/2” rear width
17” front width
3” thick with sculptured butt relief about 2” thick
seat back
19” tall
19” width at top
15” width at bottom
2” thick at bottom
1 1/2” thick at top also sculptured for lumbar support.
a bit pricey but they are comfy. It’s just another airplane part!
Jeff
KF 5
340KF
Does anyone have the series 4 seat measurements don’t trust my measurements. Would like those off the series 4 seat. Have a 3 dat trip planned for May and would like them completed by then. My one piece seat is very uncomfortable
No. I bought these direct from Oregon Aero. They are for series 5 thru 7
Jeff
KF 5
340KF
So you got bare foam cushions from Oregon Aero for DIY upholstery? I have looked on their web site a few times and didn't find any Kitfox offerings.
Kitfox 5 (under construction)
Commercial SE/ME, CFII
That is what I did. Give them a call. They make more than they advertise!
Jeff
KF 5
340KF
Mine seemed a little long in that direction too (Model 5). What I do is install them first with the front edge even with the front of the seat pan, then I put in the seat backs.
Phil Nelson
A&P-IA, Maintenance Instructor
KF 5 Outback, Cont. IO-240
Flying since 2016