I have looked over my wing tips thoroughly and don’t see any scribe lines. Does anyone have a picture of the lines where I am supposed to trim the wingtips?
I have looked over my wing tips thoroughly and don’t see any scribe lines. Does anyone have a picture of the lines where I am supposed to trim the wingtips?
They should be about 1" in from the edges.
Jim Ott
Portland, OR
Kitfox SS7 flying
Rotax 912ULS
Are they on the gelcoat? The only lines I see look like they might be for a cutout on the front for landing lights.
my wing tips were very lightly scribed. Your looking for what amounts to a baby fine hair type line in the gel coat. Mine were only about 1/4 to 1/2 in from the edge and they weren't consistent all the way across. I had to find the line at one end and stretch tape to the next spot I could find. In the end my tape was straight and I cut the excess off. Beautiful.
Eddie Forward
Flying
SS7, 912iS, Garmin G3X
If I were to do mine again, I would ignore the scribe lines and just make the tip square while removing as little material as possible
------------------
Josh Esser
Flying SS7
Rotax 914iS
AirMaster Prop
Edmonton, AB, CWL3
Thanks guys.