If I install it as is, my panel will more or less be where the pink line is. I want it where the blue line is so that the black bezel is against the panel without the gap between the bezel and the tray showing.
If I install it as is, my panel will more or less be where the pink line is. I want it where the blue line is so that the black bezel is against the panel without the gap between the bezel and the tray showing.
------------------
Josh Esser
Flying SS7
Rotax 914iS
AirMaster Prop
Edmonton, AB, CWL3
Josh,
I don't recall my Garmin Transponder being like that - might want to do a quick check to assure the the locking tab is not pointing up preventing the unit from sliding fully in.
Dave S
Kitfox 7 Trigear (Flying since 2009)
912ULS Warp Drive
St Paul, MN
Hey Dave, the pin is in correctly. It's resting flush against the tray tabs.
------------------
Josh Esser
Flying SS7
Rotax 914iS
AirMaster Prop
Edmonton, AB, CWL3
Had same issue with mine. (Going from memory three years ago...)
Your lock pins are wrong. The case bottoms out in the tray and the one pin holds it in. The second pin is inside the tray.
Also check to be sure the plug in the back of the tray is correct allowing the case to go all the way in.
Hey Larry I'm not sure I follow what you are saying. As it is now, the bezel hits the tabs circled in pink. I've attached what the connections in the back look like. Even if I could get the bezel further back in the tray, it could only push another 1/16" into the connections.
------------------
Josh Esser
Flying SS7
Rotax 914iS
AirMaster Prop
Edmonton, AB, CWL3
Josh,
Oh well...it was a shot in the dark
It appears to me that from the last photo, you may have to mount the tray a little deeper with the two tabs you circled flush with the panel.
My apologies if this isn't as helpful as I wish it was......It would be much easier if we could all be in the same room to figure it out
Dave S
Kitfox 7 Trigear (Flying since 2009)
912ULS Warp Drive
St Paul, MN
I think the tabs circled in pink will go under the face plate.
I'm sorry I don't remember more but I had the same issue and had to rethink the whole thing and then it fit.