I did the same as John, using a die grinder with a 3" wheel to do the initial cuts. Then I finished the plexiglass windows using a mini belt sander. Other than the little pieces getting everywhere I didn't find the job too bad.
I did the same as John, using a die grinder with a 3" wheel to do the initial cuts. Then I finished the plexiglass windows using a mini belt sander. Other than the little pieces getting everywhere I didn't find the job too bad.
Phil Nelson
A&P-IA, Maintenance Instructor
KF 5 Outback, Cont. IO-240
Flying since 2016
Reading the posts about the windows and cowl reminds me of the old days when I was assembling my first Model IV in a shared hangar at the Livermore airport. Driving to the hangar each day, I would see several hangars with large white patches on the tarmac outside their main doors. You could always tell who was building a Vari Eze or a Glassair.
So Far the nastiest part was putting the wings on and setting the sweep and twist for the initial install. Very stressed out at that time for fear of getting that wrong.
Eddie
Just to clarify... The fitting of the cowl was not a problem. The quality of the glass work was poor at best. Some of the most fragile areas (around the inlets) were nothing but a thick area of gelcoat that cracked away at the first flex. The gelcoat around the windshield lip was not cured properly and had pulled up to look like "brain". (Does anyone check this before it goes out?) The windshield trim line on the upper cowl was not even. The separating edge (left and right) thickness was neither straight nor consistent in thickness and the inner layer of the cowl was extremely rough and had to be ground down with 40 grit on a DA sander.
I plan to use the cowl as a starting point. Add some foam here and there to reshape, air inlets for throttle body adn oil cooler, etc etc. Make a plug and then a mold, then a part.
Jeff
KF 5
340KF
Good evening! I hope nobody has heartburn over me chiming in on this topic of the glass parts. For those not aware, we have brought ALL fiberglass in house and is being managed and mostly laid up by yours truly. There are challenges with the age of the tooling and how many thousands of parts that have been pulled from these moulds. We are working to update and repair the moulds as we can. Having said that, anyone who has experienced the focus on finish and quality I/ we have put on the wing shop items specifically can rest assured that the same attention to detail is a primary focus in the glass shop.
I can't guarantee that the parts will be plug and play. I've never seen any fiberglass that didn't require fitting and finishing. Hahaha😂😂
Take care,
Brandon
Brandon, I for one appreciate your chiming in. It should be understood that these parts are unfinished products for us to finish. My wing tips were great. I only had to knock off some gel coat and fill in some bubbles. The lengths were spot on and I didn't have to do anything on the trailing edge. My Engine cowls were pretty good all things considered. Unfortunately, at first glance, a builder is not really clear on what is expected of us and when we see how gnarly the inlet holes are with all the excess material and the jaggedness of the margins, we freak out a little. Some of my edges, at the windshield for example, are straight and leave me little to modify. My fiberglass experience so far has been pretty fun. I bought some fiberglass the other day and put my tear drop bubbles in yesterday.
Hope you get the resources for the new molds so that the parts come out without the holes in the gel coat that you guys are having to use bondo to fill before delivery. Sure glad your providing a decent product that I can work with, i will say that.
Thanks
Eddie
Brandon
Glad to hear you are taking this on! You sound like a "get it right" guy. More good news from Kitfox!
Jeff
KF 5
340KF