Jim, there are NO holes on the ends. They are just very skinny; just two tabs sticking out of the capacitor. The tab ends are pointed and slightly turned.... weird!
Jim, there are NO holes on the ends. They are just very skinny; just two tabs sticking out of the capacitor. The tab ends are pointed and slightly turned.... weird!
Grover Wright
Flying a KF IV-1200
ROTAX 912UL
Grover,
Do you have a picture and/or a manufacturer and part number for your cap?
Edit, if it's the same cap that's pictured earlier in the thread, it's designed to be soldered into a PC board. No reason you can't solder wire to thos tabs, but I personally like the screw terminal type in this application. You're also more likely to fin mounting hardware for them.
Last edited by Av8r_Sed; 02-07-2017 at 03:03 AM. Reason: addendum
-- Paul S
Model III SN910
582 IVO Med
Hi Grover,
I got the same type capacitor in my kit, and I believe those are solder tabs. I decided I really wanted to have screw terminals so I got a really nice one with screws and a higher voltage rating also (50 v.). Not trying to encourage anyone else to do that (spend more money when you have a perfectly good part to begin with), but that's what I did.
John Evens
Arvada, CO
Kitfox SS7 N27JE
EAA Lifetime
Chap. 43 honorary Lifetime
John, where did you get your new capacitor? I want screw terminals as well.
------------------
Josh Esser
Flying SS7
Rotax 914iS
AirMaster Prop
Edmonton, AB, CWL3
Hi Josh,
I bought it online from Digi-Key -
https://www.digikey.com/products/en?...ds=493-8948-ND
John Evens
Arvada, CO
Kitfox SS7 N27JE
EAA Lifetime
Chap. 43 honorary Lifetime
Thanks John. Interestingly, the Rotax manual recommends 22000uF for the 40A alternator too.
------------------
Josh Esser
Flying SS7
Rotax 914iS
AirMaster Prop
Edmonton, AB, CWL3
I found out that Silent Hektik recommends even higher ... 33,000 uf? My capacitor is “beefier” than the original at a 50v rating, but still 22,000 uf. There may be some potential benefit to a higher micro farad rating, with no real downside. It’s still unclear to me what the capacitor actually does in this circuit. I’ve read some descriptions of that which are obviously incorrect. When I take the time to find out for sure I’ll post it on this forum. Of course there are people participating here who can probably tell all of us the real facts already.
John Evens
Arvada, CO
Kitfox SS7 N27JE
EAA Lifetime
Chap. 43 honorary Lifetime