Id love to see the install instructions or pictures of how you get the wire from the aft fuselage to the rudder! Can see to picture it in my head
Id love to see the install instructions or pictures of how you get the wire from the aft fuselage to the rudder! Can see to picture it in my head
I’ll try to take pics today. I used a TIG welding rod to fish the wire from the aft edge of the rudder to one of the hinge cut outs on the front edge of the rudder. I then used a long drill bit to drill a hole in the fiberglass on the back side of the vertical and installed a rubber grommet in the hole for the wire to pass thru. I did the install without removing the rudder.
Sent from my iPhone using Tapatalk
Ben Bell
Building 7 super sport
O200 powered
Not the greatest pictures but you can see how I ran the wire. It will be secured to stay out of the rudder stops. (Side note) you can also see how I addressed the rudder stop issue that some have. I drilled and tapped a hole on the rear stop and used a Phillips head screw with appropriate washers to adjust rudder travel so that the rudder wouldn’t contact the elevator.
Sent from my iPhone using Tapatalk
Ben Bell
Building 7 super sport
O200 powered