-
Fuel Hose sizing
My plane currently has a mix of hose type and sizes. From the right wing shutoff valve to the header tank, it's 1/4 inch aluminum. From the left wing shutoff, it's 5/16 rubber. From the header to the front, it's 1/4 inch aluminum transitioning to 1/4 inch rubber just before main the valve.
My original plan was to leave all the aluminum in and replace just the rubber but I was not able to remove the old AN fittings without twisting the line so I'm thinking of just going all rubber up to the firewall (the line through the firewall to the gascolator is OK).
My first thought is to go all 5/16 including a new shutoff. Is there any point if hard line to the gascolator is 1/4 inch? Should I just go 1/4 inch rubber from the header to the main shutoff?
-
Super Moderator
Re: Fuel Hose sizing
IMO, I don't like rubber lines in the cabin other than the flex needed to fold the wings.
I just got all the fittings and lines to do my project plane in 5/16" aluminum line. It cost me about $75, including line, fittings and 3 ball valves.
Av8r3400
Kitfox Model IV
The Mangy Fox
912UL 105hp Zipper
YouTube Videos
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules