I am thinking about changing the bungees on my Model III. I could buy them from Kitfox or Highwing LLC, but was thinking about building my own.
Where is everyone sourcing the materials, and what problems will I run into.
Loue
I am thinking about changing the bungees on my Model III. I could buy them from Kitfox or Highwing LLC, but was thinking about building my own.
Where is everyone sourcing the materials, and what problems will I run into.
Loue
Aircraft spruce has bungee for this application, you can crimp the big aluminum nicopress' on if you have a tool or you can just wrap them with safety wire thats what I did. just make sure you pull the loops tight before wrapping them or they will pull when installed. here is some good info on making them, and a jig to pull the loops tight. http://avidflyer.wikia.com/wiki/Shoc...nd_Replacement
they are pretty easy to make and will save a lot of money
enjoy
One thing I would recommend is to buy a bit extra of bungee cord. 2 or 3 feet so you will have 1 or 1 1/2 feet to hang onto when you are doing the last wraps on the bungees. When you finish the last wrap, loop it around where it hooks on, and tie off the loop with saftey wire while the other guy is holding the extra remaining bungee, then cut it off after you have tied the loop. It also helps to mark the bungee with a magic marker where each wrap should cross the seat truss. That way you know you've pulled enough for each wrap. Jim Chuk
Thanks for tips. I read the article that was suggested, and plan to follow it. the one thing that I am not sure of is the article calls for 3/8" shockcord, 90" long with 7 wraps. I think that the build manual for my Model III calls for 6 wraps, and I thought that they were 60" long.
Does anyone know for sure?
thanks, Louie
The 90" dimention is about what an Avid Flyer would use, and the 60" is about what a Kitfox uses. Jim Chuk
Thanks, that is what I thought, but you always like some conformation.
Louie