Ok I just drew the eagle on the wheel pant,..Yeh or Nay,..
too much Bling or not?
Ok I just drew the eagle on the wheel pant,..Yeh or Nay,..
too much Bling or not?
Chase
Model 5 OutBack
912 UL
No way! I think the size is perfect! Looks good SkyPirate. Do it!
Chris Holaday
Looking at the Model 5 or newer for size!
you guys must read minds lol ,..I was actually on the phone this afternoon with the place that's putting the eagle on the wheel pants ,..I'm getting my new N number put on,.. "SkyPirate" put on pilots door, and the eagle put on the wheel pants no tailwheel pant though,,
Last edited by SkyPirate; 01-14-2014 at 06:55 PM.
Chase
Model 5 OutBack
912 UL
there is a local shop Aerographix they do RC and full size aircraft graphics ..located in rolla Missouri,..I will post pics when it's done
http://www.aerographix.biz/_borders/...ledoBanner.jpg
Last edited by SkyPirate; 01-14-2014 at 09:34 PM.
Chase
Model 5 OutBack
912 UL
Cool! looking forward to the pics
Dorsal ~~^~~
Series 7 - Tri-Gear
912 ULS Warp Drive
without eagle on pant
Chase
Model 5 OutBack
912 UL
thinking maybe I could get vinyl ones made and if it turns out to be too much,..could peal them off
Chase
Model 5 OutBack
912 UL
Thanks Chris,..
Chase
Model 5 OutBack
912 UL
Looks awesome, Skypirate!
I'm in the middle of this process, now my PH-FOX actually flies..;-))
And I can't get an idea how to attach the pants to the Groves...like you did.
Is there a drawing of your attach-plates available? The manual doesn't mention Groves, and the SS-manual gives a plate-idea, but that somehow doesn't fit. Perhaps my pants are different, dunno... I bought FOX as a project, and the pants are Spruce, I think.. I can't bend them out so far that one side is at the end of the axle and the other side is outside the Grove.. I miss some 15 mm.
Your solution might not give me a perfect answer (although it sure looks that way) but might give me a different angle to look for...