I just started running wire. I'm wandering are more people crimping the #6 awg or soldering. I was told to stay away from soldering if you can. Looking for advice from more experienced than I. Thanks
Patrick
series 6 builder (wiring)
I just started running wire. I'm wandering are more people crimping the #6 awg or soldering. I was told to stay away from soldering if you can. Looking for advice from more experienced than I. Thanks
Patrick
series 6 builder (wiring)
Actually, I do both with big wire....
I don't know what the issue with solder might be, maybe it just takes longer, or maybe folks think it will melt. Your insulation will melt first, I can tell you that.
Roger
solder is always better in my book, and dyolithic grease on bolt on connections
Chase
Model 5 OutBack
912 UL
Solder makes for a rigid connection which can, in some cases, invite cracks and failures of the connection.
Not an expert, just what I have read and heard from other builders.
Having flown with and hung around with an actual "rocket scientist", he helped build the guidance system in the Space Shuttle, who said on more than one occasion that there were no soldered wire connections on the Space Shuttle. Only crimped. The soldered wires will fatigue at the solder and the wires will break if not properly strain relieved. I sure don't know that for a fact but I can tell you there were no soldered connections in his Kitfox. I did mine like his, mostly.
I had an electrical issue last week that I think I discovered today and fixed. Yes, it was one of the very few wires I broke with his wiring edict and soldered to my avionics master relay. It took 10 years of flying to finally fatigue and cause a nasty intermittent problem. I thought I had it well strain relieved too.
I know Ray Volk is looking down from Heaven saying, " I told you so".
DesertFox4
Admin.
7 Super Sport912 ULS Tri-gear
I also do not use solder for the reasons stated above, I crimped my engine ground cable with the swaging tool.
Dorsal ~~^~~
Series 7 - Tri-Gear
912 ULS Warp Drive
Well I have to say that if NASA personel says to crimp, Crimp it is!!!!!
Thanks for the posts gentlemen!!!! All info is appreciated!
stady away from solder --it can cause fatigue.
use good crimpers - ratchet style. not cheapies.
Know how to tell a good crimp fom a poor one.
You can also use a few inches or so of heat shrink to put over the connector after connected. This will provide some strain relief to the connection.
Cheers.
Soldering #6 wires on a small plane like a KF is not so bad. For smaller wires crihis is common practice in the aviation and automotive industries.