I believe Kitfox sells plastic endcaps, look in the catalog.
I believe Kitfox sells plastic endcaps, look in the catalog.
Dorsal ~~^~~
Series 7 - Tri-Gear
912 ULS Warp Drive
Yes we do.. for both the Symetrical and Asymetrical.
Symetrical and Asymetrical, without actually comparing the 2 side by side . what is best way to tell what flap i have? they both look the same?
this sight rocks ,you people are wonderful help. now i just need order a couple.![]()
I used balsa wood here and also to fair the ends of the horizontal stab and elevator with epoxy varnish as a finish. Much less prone to hanger rash.
Jim
I guess right now I am favoring the foam. This might be a good time to learn a new technique. The foam is designed to be covered with a hard epoxy like surface that can be sanded. My original plans called for using the 3M structureal adhesive - a beast to sand. Do a search for microballoons and get some. You may find it locally. It is a glass powder that consists of microscopic hollow glass spheres. When mixed with epoxy resin, it acts as a filler and by proportioning the mix, it makes up a bondo like substance, but much easier to sand and very light weight. depending on the job, I like it in a very thick almost runny consistency to stiff peanut butter like. I mixed it in the 2 oz. portion cups available at Costco or Sams Club.
I used this everywhere on my airplane. You can use it on top of the wing tanks to get rid of the annoying sags on the top surface - that do show through the fabric. It can be used on the cowl to finesse the top and bottom joint or to fill oops drillled holes or those annoying bubbles in the gelcoat. On the flaperon ends, it is definitely out of harms way and though made of foam, you will never find it deforms unless more than the tips are damaged.
It might take several applications, sanding between and for the final layor on a flat surface, I use a single edge razor blade as a squeegee.
Lowell
We used balsa wood with a thin coat of epoxy over it. Worked out very nicely.