Hey Stan,
I interpreted the instructions to mean use the plastic washer under the screw head.
Hey Stan,
I interpreted the instructions to mean use the plastic washer under the screw head.
Last edited by Dave S; 07-23-2016 at 10:38 AM.
Dave S
Kitfox 7 Trigear (Flying since 2009)
912ULS Warp Drive
St Paul, MN
Agree with Dave.
Jim Ott
Portland, OR
Kitfox SS7 flying
Rotax 912ULS
Thanks guys. Did you use a washer with the locknut?
Stan Inzer
912 ULS
Dynon Skyview 10"
N599KF
I would like to know if more people have had negative experience with LP Aero acrylic than positive- mine was pretty much the same as most on this thread, spent $800 on doors and install kit(with the acrylic drill bit) had the right side crack on the 3rd hole and the left split on trimming after wasting two days fitting and screwing around. I got so fed up I put the original doors back on and said screw it!!! For that kind of money you can get a pair of doors for a car that actually fit without screwing around...... Ok rant over
I succeeded at drilling all my holes for the doors only to split a crack out to the edge on two screws when I tightened them down onto that soft pliable tape that the window is mounted on. Didn't require too much torque to do it either.