-
-
Senior Member
Re: Need help one more time!
Jacques,
Unless someone is just starting this step, I doubt these dimensions are readily available. Once the bends are made, they would only be approximate. I don't think the specific measurements are critical, only relative. I would start at one point - one support - then fabricate and mount it, then proceed to fit and mount the others. Another thought would be to mount it to the firewall or the aft section of the engine mount. That requires longer ignition wires at some locations, but eliminates the wire damaging vibrations.
Lowell
-
Re: Need help one more time!
Ok, thanks.
I will try both : longer ignition wires to avoid problems and built by myself these parts. I will keep the best solution.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules