Kitfox Aircraft Stick and Rudder Stein Air Grove Aircraft TCW Technologies Dynon Avionics AeroLED MGL Avionics Leading Edge Airfoils Desser EarthX Batteries Garmin G3X Touch
Results 1 to 10 of 37

Thread: Intermittent Electric Trim Actuator

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Administrator RandyL's Avatar
    Join Date
    Mar 2008
    Location
    Woodinville, WA
    Posts
    207

    Default Re: Intermittent Electric Trim Actuator

    Good idea John, a relay sounds like a smart move and one that should extend rocker switch life given the constant use the trim actuator gets in a Kitfox (for trim rather than flaps as in an RV). Here is the relay board commonly used in RVs, seems like this would be perfect for our application.
    cat-med_flap-board.jpg

    $39.50 and available from Van's Aircraft .
    Randy Lervold
    TeamKitfox.com Admin Emeritus
    Day job: www.dynonavionics.com

  2. #2

    Join Date
    Sep 2012
    Location
    San Francisco
    Posts
    100

    Default Re: Intermittent Electric Trim Actuator

    Sorry to bump this 13 year old thread but thought I would post because its still an issue. I have a Series 6 and had this intermittent trim problem at around 90 hours flight time. This thread mentions two causes of the intermittent trim problem: 1) gunk in trim motor's commutator and brushes and 2) arcing in the switch.


    First a warning. Although others seem to have successfully taken the trim motor apart, cleaned it, and put it back together, it's not for the faint of heart. As careful as I was during disassembly, four washers fell out leaving me scratching my head as to the proper order and I didn't want to guess. Other problem is that getting the brushes back properly is very difficult. My suggestion is to do what I did and just order another trim motor assembly from John McBean.


    In my case, the problem turned out to be arcing in the switch (see photos). I was initially fooled into thinking the switch was fine because when I removed the connector to the trim motor and measured the voltages there I got +12V with down trim activated and -12V with up trim activated. The issue though was that because of the worn contacts, the resistance was too high. Replaced the switch, and all worked fine.


    Since this problem has not been reported since 2008, my guess is that only the Skystar kits that had the old arc-prone trim switch. The new rocker switch from John McBean is different.

    Attached are photos of the affected Skystar switch, the messed up contacts, the delicate brush assembly of the trim motor, and the washer assortment that fell out when I opened the motor up
    trim-motor-washers.jpgtrim-motor-brushes.jpgtrim-motor-switch-contacts.jpgSkystar-switch.jpg

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •