Dave - Looks like they got the picture thing fixed.

Picture 1 is setting it up with the #13 drill bit. Picture 2 (your pic) - your arrow is where a #25 bit is slid in between (vertically in this pic) the ferrel and the nico fitting. Picture 3 is how mine turned out using the #25 bit method. With your set up in picture 2 where you''re using the cleco pliers to hold it all together (a great way to do it) should make the #25 drill bit method pretty easy. Squeeze it till the drill bit doesn't fall out between the nico fitting and the ferrel and then crimp it. Once you've done the first crimp (the center one) you can pull the drill out. Remember to put some shrink tubing over the cable before you do all this so you can cover it all and take care of any pesky cable wires that might want to pop out at the back of the nico fitting.

Gary


Picture1.pngpicture 3.jpgPicture2.png