Walking around the fuselage to get hardware from stock can require hundreds of trips. Why not bring the stock room to you?
I made this rolling parts bin from two wall shelving units bolted back to back. They are from Harbor Freight and set me back about $60 each on sale. I added a plywood top with fiddles to keep things from rolling off the top. On the bottom I attached four swiveling casters, also from Harbor Freight.
The bin rolls easily around the shop and it saves countless steps. I use the top shelf as a tool tray to keep reamers, taps and drill bits close at hand.
I labeled the bins with strips of white plastic electrical tape marked with a super fine felt pen. The tape just peels off when I need to relabel a bin. The bins hook on the shelves and are easy to rearrange for sequential part numbering and sorting.
Right now is it exclusively Kitfox parts and hardware. When the aircraft is done I'll have a nice roll around bin for the next project.
I’m sure everyone has used one of these cans with plastic snap caps. They are a pain in the cartouche to open requiring a screw driver almost every time. Soon the pry tab breaks off and it’s a bear to get the can open.
Push a drywall nail through the cap to make a tiny hole. When you need some thinner or solvent just pick up the can and squirt out what you need.
You can use the nail as a plug, if you like, but I found the hole is small enough to prevent noticeable evaporation even over extended periods.