How can i weight my plane for cheap??

[rogerh12]

Howdy;

Anyone know how to weigh my kitfox 4 accurately, but on the cheap?
My airport can't even weigh a plane that is less than 1000lbs, and they charge a bundle

Special bathroom scales, known to work good?

any help is appreicated.

Roger

[Av8r3400]

Contact you local EAA chapter. They often have access to someone (or they have themselves) aircraft scales.

Local chapters, even inactive ones, are a wealth of knowledge and resources.

[t j]

Three $14 scales I calibrated myself with known weights. If you need help get only one person. It is a simple process but some people make it way to complicated and it seems no two agree on the process.

[N82HB]

I agree with Tom. That is a very easy way to get good numbers.
Just remember to remove the weight of tailstands etc.

[Dorsal]

I did the same with a single scale and two "dummy" scales (blocks of wood of the same thickness as the scale).

[Slyfox]

Three $14 scales I calibrated myself with known weights. If you need help get only one person. It is a simple process but some people make it way to complicated and it seems no two agree on the process.

those look like my scales, hay give them back

[MotReklaw]

I did my two homebuilts the way Tom did.

[jtpitkin06]

If your bathroom type scale does not read high enough to weigh your aircraft, you can double the range with a plank and spacer. Place the scale under one end of the plank and a spacer the thickness of the scale under the other. Chock the aircraft wheel in the middle of the plank. Multiply the scale reading by two and subtract the weight of the plank. (The scale registers only half the weight of the plank, but you multiplied it by two.) The length of the plank doesn't matter, but a longer one, say about six feet, is more accurate.

[vetdrem]

Using the plank and spacer will work, but you need to be sure that the weight of the plane is exactly centered on the plank between the spacer and scale. If not, the results will be VERY inacurate.

What I do in the case where I don't have a scale large enough for the job is to use two scales and a plank. with the plank between the two scales and the planes wheel anywhere in between, add the readings of both scales, subtract the weight of the plank, and you have the weight of that wheel. Very accurate and easy (no higher math, like multiplying by 2).

Another important point that was mentioned before, but is so important that it needs to be addressed again, the plane needs to leveled again each time the rig is moved from one wheel to the next.

I also agree with the use of only one helper.

Louie

[Dorsal]

Vet, I like that approach, simple and effective plus you don't have to figure exactly where the center of pressure of the tire is. I am planning on weighing my plane again but as I don't want to drain the tanks it will be done with full tanks and then subtract the fuel, this will surely put it over the capacity of my scale. It is also a huge load off my mind to know I can do this using only addition and subtraction and avoid any complicated multiplying and ratios