Kitfox Aircraft Stick and Rudder Stein Air Grove Aircraft TCW Technologies Dynon Avionics AeroLED MGL Avionics Leading Edge Airfoils Desser EarthX Batteries Garmin G3X Touch
Page 3 of 3 FirstFirst 123
Results 21 to 22 of 22

Thread: Kitfox "Royale" Rotec

  1. #21
    Senior Member
    Join Date
    Dec 2008
    Location
    Garland, Texas
    Posts
    1,476

    Default Re: Kitfox "Royale" Rotec

    I found the link it is on the Rotec Page, customer project Neil Rings Project.
    http://www.rotecradialengines.com/cu...s/NielRing.htm

  2. #22

    Join Date
    Oct 2008
    Location
    paul
    Posts
    62

    Default Re: Kitfox "Royale" Rotec

    Hi Paul Z,

    I had not seen that! Very good that’s the same as mine. The tube is all 1/2" x .049" 4130. If one is making it themselves care needs to be taken to correctly set the offset between the top cups and the lower pins, there is a slight stager. In that PDF the rubber cushions are not shown but the measurements have included there presence.

    It’s the perfect mount for this engine because the geometry clears the starter and 40A alternator with out having to cut the tubes on either side.

    To convert mm to decimal inches divide mm by factor of 25.4 eg 100mm divided by 25.4 = 3.937”

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •