Kitfox Aircraft Stick and Rudder Stein Air Grove Aircraft TCW Technologies Dynon Avionics AeroLED MGL Avionics Leading Edge Airfoils Desser EarthX Batteries Garmin G3X Touch
Page 5 of 5 FirstFirst 12345
Results 41 to 42 of 42

Thread: 912 exhaust connections

  1. #41
    Senior Member Dusty's Avatar
    Join Date
    Dec 2012
    Location
    Christchurch, New Zealand
    Posts
    378

    Default Re: 912 exhaust connections

    Out of interest, how many hours has this exhaust done?

  2. #42
    Russell320's Avatar
    Join Date
    Oct 2009
    Location
    Chandler, AZ (P19)
    Posts
    93

    Default Re: 912 exhaust connections

    Mine had approximately 700 hours in service. One of the things that I think made it difficult to separate the header from the muffler is the use of Decalin RunUp. There was quite a bit of residue all over the internal parts of the exhaust system.......but it’s better than lead. And yes, I agree, there should be ball joints instead of slip joints.

    The headers are now on the way to Kitfox to be matched with a new muffler.$$$$$$
    Russ
    Model IV Speedster
    912UL IVO IFA
    RV6A
    Needle, Ball and Airspeed
    Maybe a little GPS

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •