Hello Dave,
I used a Brother Label Maker with black letters printed on 1/4" clear tape.
See more here!
All the best,
Tom
Hello Dave,
I used a Brother Label Maker with black letters printed on 1/4" clear tape.
See more here!
All the best,
Tom
Kitfox SS, 912 ULS
http://tropicaltuba.com/Kitfox%20Project/Kitfox.htm
Tom,
I have been following your build website and noticed you have installed your panel and are now wiring it. FWIW I found that it was MUCH easier to install all the panel components and then prewire as much of them as possible on the bench. Then install the panel in the airplane and finish up the wiring. In fact I came up with a way to pivot the panel down 90 degrees so the backside was facing up, which made the final "in-place" wiring much easier.
Jim Ott
Portland, OR
Kitfox SS7 flying
Rotax 912ULS
I gave serious consideration to prewiring the panel on the bench but, in the end, I decided to wire it in place. My avionics-rocket-scientist friend is coaching me on assembling the harnesses on the bench and then installing then in the panel. I'll probably have to remove the radio mounting bracket to install the molex connector and antenna lead.
It goes without saying that I may regret my decision. If this happens I'll "fess-up" on the website.
At the moment my avionics-rocket-scientist friend is on some South Pacific Paradise Island fixing a radar station. I hate it when he abandons me like this.
Kitfox SS, 912 ULS
http://tropicaltuba.com/Kitfox%20Project/Kitfox.htm
My panel by a kitfox III with rotax 582
as of today thanks to a couple on field friends
Chase
Model 5 OutBack
912 UL
Chase,
That looks nice and clean. Good layout.
Steve Wilson
Huntsville, UT
Kitfox 85DD
912A / 3 Blade Taper Tip Warp Drive
Convertible Nosewheel & Tailwheel
SkySteve's SPOT Page
SkySteve's You Tube Videos
Thanks Steve,..once my A&P friend gets done with the wiring it will be set down under the panel support tabs on the bottom,..he is making the radio wiring harness now
Chase
Model 5 OutBack
912 UL
can't wait to try her out
Chase
Model 5 OutBack
912 UL
Nice job Chase.
DesertFox4
Admin.
7 Super Sport912 ULS Tri-gear
That's going to be nice. Did you decide where to install the inclinometer?
Mike Bentley
Model IV-1200
Jabiru 2200A #438
Rotec Aerosport LCH Heads
Ellison EFS-2 Throttle Body
Prince Prop (64x34)
My SPOT Page