-
Putting trim actuator motor to 12V
Newb question: ?m installing my trim actuator and need to run it to full nose up to test the required travel of my horizontal stab. After wiring the switch to the actuator, the instructions say to connect to a 12V battery to test. Can I do this without any breaker protection? Without buying a power supply, the only 12V batteries I have are car batteries. That sounds like a lot of potential amps.
-
Re: Putting trim actuator motor to 12V
You can test it for travel with a 9 volt alkaline battery. It'll run slow, but it will give you the travel
Bob
-
Re: Putting trim actuator motor to 12V
thank you. Worked perfectly
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules