Kitfox Aircraft Stick and Rudder Stein Air Grove Aircraft TCW Technologies Dynon Avionics AeroLED MGL Avionics Leading Edge Airfoils Desser EarthX Batteries Garmin G3X Touch
Page 2 of 2 FirstFirst 12
Results 11 to 12 of 12

Thread: Center Console Top Installation

  1. #11

    Join Date
    Sep 2010
    Location
    ca
    Posts
    167

    Default Re: Center Console Top Installation

    I ran into a bit of this myself, but just opened up the slot a very little bit. When I clecoed the detent bracket in place I found a slight rub on one side with the handle forward and a little rub on the other side with the handle aft. I took the detent bracket apart and ground the inside surfaces down in the areas that were rubbing. It only required a few seconds work with my pneumatic disc sander (super handy tool for this type of thing) and all was good. I notice that there is a very tiny bit of side to side play in the flap handle and consequently the potential for rubbing if I push to one side or the other. I think I'll probably put some thin UMHW tape on either the inside of the bracket or wrap the handle with it so that nothing gets beat up over time.

  2. #12
    dginok's Avatar
    Join Date
    Aug 2009
    Location
    Norman, OK
    Posts
    92

    Default Re: Center Console Top Installation

    Dave, what did you use to bend the flap tube?
    Doug
    Super Sport
    912ULS
    Constant Speed IVOProp


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •