I am in the home stretch of my install of my G3x and need some input. What oil pressure sender are you using? The stock one has one lead and the G3x manual has 2 leads and a ground.
Thanks,
Dave
I am in the home stretch of my install of my G3x and need some input. What oil pressure sender are you using? The stock one has one lead and the G3x manual has 2 leads and a ground.
Thanks,
Dave
Dave
KitFox 6 Taildragger
912 ULS
Whirlwind 70” Prop
Garmin G3x
All around nice guy
I can’t be the only person on the planet with a G3x, Rotax 912 combo or am I?
Dave
KitFox 6 Taildragger
912 ULS
Whirlwind 70” Prop
Garmin G3x
All around nice guy
You have an 912 ULS? I used the leads from the stock rotax one and connected it to GEA-24. If I recall garmin specs how you wire it depending on the part number of the sending unit. Seems like in the wiring examples they show both sending units. I though if you look on the sending unit for oil pressure it had the part number labeled? You then also have to select the correct sending unit in Garmin config to make sure your displaying correct oil pressure. They are off about 10psi if I recall.
Last edited by Shadowrider; 11-29-2022 at 09:37 AM.
Dustin Dickerson
Building 7ss STI x 2
Oratex
29" shock monster
EP912STI 155hp
Garmin
N33TF......FLYING!
N53TF......FLYING!
Here is the one I installed in my 912ul.
It's possible you might need a metric adapter. I did not in my case.
Garmin G3X Oil Pressure 150 Psig 1/8-27 NPT Sensor Kit | Aircraft Spruce
"Somebody said that carrier pilots were the best in the world, and they must be or there wouldn't be any of them left alive." Ernie Pyle
Brett Butler
Flying: N46KF, 1998 Model 5 Outback, 912ul 110hp, G3x with 2 axis a/p, Beringer wheels & brakes, SS7 firewall forward, NR prop, Custom paint
Screenshot 2022-12-04 at 2.51.18 PM.jpg
I was looking into this recently as well. There are a couple different ones. From what I can see they will both work provided they are wired correctly. I haven't powered it up yet so don't trust that diagram but I did write the wiring difference and the part numbers.
🇨🇦CANADA
Flying | SS7 | G3X | Edge 912
So my sender has a red, green and black wire. My harness pins out from 17 and 18. Does the black wire from the sender just go to the ground?
Dave
KitFox 6 Taildragger
912 ULS
Whirlwind 70” Prop
Garmin G3x
All around nice guy
Nobody on this forum is using a Garmin oil pressure sender? Perhaps I'll just guess and hope the smoke doesn't leak out of the G3x. If it does leak out, how do you get the smoke back in?
Last edited by desertdave; 12-18-2022 at 12:07 PM.
Dave
KitFox 6 Taildragger
912 ULS
Whirlwind 70” Prop
Garmin G3x
All around nice guy
Update..... The Garmin oil pressure sender is made by Kavilco. SteinAir helped me out with the pin out.
Dave
KitFox 6 Taildragger
912 ULS
Whirlwind 70” Prop
Garmin G3x
All around nice guy