Adding Fuel Site Tubes

[RoyHelsing]

I added them to my Model III. No special reinforced bosses required. I used fuel tank grommets from JBM Industries like these:
JBM Industries Fuel Tank Grommets.jpg


The tubes I used the Ethanol proof blue Bing fuel line, even though I don't use Ethanol gas. The barbed 90 deg fittings can be found at lawn equpment businesses or online. A brass wire inside helps keep the tubes straight. Installed the grommets and fittings with a little dielectric grease. I also safety wired the site tubes so they can't slip off. The placards were printed on vinyl and applied to aluminum sheet cut out to fit.

Fuel Placard.jpeg

No, the grommets have clearance to the placard. I probably used some double stick tape to attach, don't recall, it's been awhile.

Thanks. I think I am going to give it a shot.