Hello, does anyone have the wooden flaperon jigs that the manual has you build? I’d love to rent them rather than buy a band saw for a one time use. Just thought I’d check before spending money on a saw. Thanks
Sent from my iPhone using Tapatalk
Hello, does anyone have the wooden flaperon jigs that the manual has you build? I’d love to rent them rather than buy a band saw for a one time use. Just thought I’d check before spending money on a saw. Thanks
Sent from my iPhone using Tapatalk
Ben Bell
Building 7 super sport
O200 powered
Why can't you use a jigsaw?
John Brannen
Morris, IL
Sonerai IIL (Single Seat)
Kitfox 3/4 1050 - Rotax 582 (Back Flying and sold)
Kitfox IV 1050 - Rotax 582 (sold)
Kitfox IV 1200 Speedster - Rotax 912 UL (rebuilt and now flying)
Piper Twin Comanche (Sold)
Glasair 1 FT (Waiting to start)
Hmm... that's a good question and shows how new to this I am. I'm not sure. I guessing what ever comes with a new SS7 series kit, but guessing has gotten me in trouble before.
I think I knew there were two types, but cannot remember the pros/cons of each, and I also see both listed in the parts catalog, but I didn't see an option to choose on my order from for the kit. Can anyone enlighten me on the subject -- which is better for what?
Thanks.
Yeah I’m sure I could and might just do that but I assumed a bandsaw would get a much straighter cut.
Sent from my iPhone using Tapatalk
Ben Bell
Building 7 super sport
O200 powered
I'm in the same boat. I don't have a jigsaw or a band saw and don't feel like buying one for just one task. I mean, I know they're handy and it's not like I haven't seriously bloated my power tool cabinet already.
Possibly I could make a set of templates and then use my router.
Kitfox 5 (under construction)
Commercial SE/ME, CFII
Might be a bit of work, but an old-fashion hand coping saw could be used or except for covid protocols, check with local school trades dept and see if a student could make them as a project. Then again I have used my small bandsaw for much more than just the plane.
Rick
Harbor freight has a $20 jigsaw. If you are never going to use it again give it away. The new
owner will think you are a rich aviator and possibly volunteer to help you when you need help.
The model 7 kit comes with asymmetrical flaperons.
The main thing about the flaperon jig is not a perfect profile, but that it holds the flaperon so that the chord line is parallel with the bottom surface of the jig (where you will be holding your level). Some folks cut the profile a little oversize so that the can line it with a thin foam/rubber to help prevent denting the aluminum skin when you clamp on the jig.
Jim Ott
Portland, OR
Kitfox SS7 flying
Rotax 912ULS
Although not a model 7, I just had to make a jig for replacing the flaperons on my model 4 project. I hacked it out of plywood and wasn't really even that close, and then put clear packaging tape on the flaperon, slathered the mating part of the hacked out jig with JB weld and put it on the flaperon. Once cured, I had a perfectly conforming jig.
John Brannen
Morris, IL
Sonerai IIL (Single Seat)
Kitfox 3/4 1050 - Rotax 582 (Back Flying and sold)
Kitfox IV 1050 - Rotax 582 (sold)
Kitfox IV 1200 Speedster - Rotax 912 UL (rebuilt and now flying)
Piper Twin Comanche (Sold)
Glasair 1 FT (Waiting to start)