Trim Actuator Installation Problem

[Eric Page]

EDIT: Never mind; I solved the problem another way. I replaced the three bearings used to install the rudder because one had buggered up threads and another had a seized bearing ball. The third one is fine but since I replaced all three, I had an extra. It has the same 1/4-28 thread as the one on the trim actuator, but a 3/16" through-hole instead of the 1/4" hole in the bearing supplied with the actuator. I swapped the rod ends and eliminated the need for the bushing.

IMG_1374.jpg

---

I'm missing a part for the trim actuator installation and need help identifying what to buy or fabricate. Is bushing P/N 10001.116 made of bronze or steel?

Diagram from the Series 5 manual (current Series 7 is the same):

Trim Actuator Installation S5.jpg

[N14ND]

It is steel.