I've been reading through the Dynon manuals and came across a 2 amp limitation on servo current for their SV-AP-PANEL auto-trim output. I seem to recall reading somewhere that the brushed DC motor driving the linear actuator on Kitfox stab trim can pull more than this.

So, I tested my trim actuator. I pushed as hard as I dared (50-70 lbs?) and wasn't able to stall the motor, but I did get it to pull a tad over 3 amps, very briefly. However, I'd be surprised and alarmed if there was anywhere near that much force on it in flight. With more reasonable force against it (~20 lbs), current draw was around 1 amp.

Has the 2 amp current limitation been an issue for anyone using a Dynon SV-AP-PANEL to drive stab trim?