It is a mess around our country for sure Eddie. The people in southern Illinois have pretty much disobeyed the governor and continued working this time. The prop comes from New Zealand and I think they shut down is anyone sneezes over there.
It is a mess around our country for sure Eddie. The people in southern Illinois have pretty much disobeyed the governor and continued working this time. The prop comes from New Zealand and I think they shut down is anyone sneezes over there.
Harlan and Susan Payne
Flying FarmFox STI Kitfox N61HP
Rotax 915is, Airmaster prop.
https://www.youtube.com/@KitfoxPilot/videos
We have been rained out from harvest a couple days.
I finally got the panel finished and the wiring tidied up a bit, only a couple camera wires left to run when I get them.
Windshield is next if anyone has any tips they would be welcome on that subject.
Harlan and Susan Payne
Flying FarmFox STI Kitfox N61HP
Rotax 915is, Airmaster prop.
https://www.youtube.com/@KitfoxPilot/videos
Looking great! I’m open to hints and tips on the windshield also.
Sent from my iPhone using Tapatalk
Ben Bell
Building 7 super sport
O200 powered
That's looking really good, Harlan. Nice work. What is the ball valve in the second photo used for?
Eric Page
Building: Kitfox 5 Safari | Rotax 912iS | Dynon HDX
Member: EAA Lifetime, AOPA, ALPA
ATP: AMEL | Comm: ASEL, Glider | ATCS: CTO
Map of Landings
Thanks Eric, the ball valve opens and closes water for heat or no heat.
Harlan and Susan Payne
Flying FarmFox STI Kitfox N61HP
Rotax 915is, Airmaster prop.
https://www.youtube.com/@KitfoxPilot/videos
We have forward vision when the tails on the ground!
Another words I got the backup camera put on pointing forward. Haha.
Wiring is done.........again.
Harlan and Susan Payne
Flying FarmFox STI Kitfox N61HP
Rotax 915is, Airmaster prop.
https://www.youtube.com/@KitfoxPilot/videos
what magic is this??? :d
Building N137DF
STi, Rotax 915is, Airmaster
Its a wal mart magic backup camera. haha
Harlan and Susan Payne
Flying FarmFox STI Kitfox N61HP
Rotax 915is, Airmaster prop.
https://www.youtube.com/@KitfoxPilot/videos
Hey Harlan. Is that as easy as just cutting the wire to the camera, putting pins on the wires and then plugging those into the plug that attaches to the PFD?
Eddie Forward
Flying
SS7, 912iS, Garmin G3X
Eddie, I bought an adapter at menards that coverts rca to the bnc on the back of the g3x. No cutting wires at all. Very simple.
Tempo Communications BNC Male to RCA Female Adapter - 2 Pack at Menards®
Harlan and Susan Payne
Flying FarmFox STI Kitfox N61HP
Rotax 915is, Airmaster prop.
https://www.youtube.com/@KitfoxPilot/videos