Garmin G3x Wiring Questions
Hey everyone! Working on wiring and my brain hurts! I am going to have lots of wiring questions so I figured I should start another thread instead of on the build log?
I am currently working on wiring up the gea-24, which is the box that all the engine senors connect to. The manual shows (I think) a 2 conductor wire coming from the CHT to the GEA-24. It is saying most of the sensors, other than the egts, need to have Garmin Shield block ground, which I assume is grounding the shield to the backshell? Also with lots of sensors needing to be grounded to the backshell do you just start stacking the grounds? Lastly it shows the 2 conductor wire going to each CHT. One as the signal and the other grounded to the aircraft. It is showing the ground to be on the end where the CHT probe is? Not sure what you do there? Is it okay practice to run a single shielded wire from the CHT probe to the GEA-24 that then the shield is grounded at the backshell of the GEA-24, and then run another shielded wire from the GEA-24 for that CHT to the ground bus for the aircraft?
Sorry I know there is a lot of questions there, any input would be helpful!
Re: Garmin G3x Wiring Questions
Hi Dustin,
After reading the manual setup I had the harness made for my whole G3X system, this is one area I felt it was better to have someone build it that did it every day. I used Steinair for this service.
Jim
Re: Garmin G3x Wiring Questions
I know the feeling! Seems like I need to just hire someone to come out and wire it all up for me🙂
Re: Garmin G3x Wiring Questions
Steinair was a great company to work with, very patience and helpful. I am going to be painting this fall and hope to fire up the panel before year end.
Re: Garmin G3x Wiring Questions
Don't be fooled by the belief that the shop has people who do it everyday. You might be surprised, as I was. Go with Stein Air. They sponsor this site too.
Re: Garmin G3x Wiring Questions
Hi Eddie! Yeah I think I am going to charge forward trying to figure this out. Looking back I think I would have gone with AFS or Dynon pre-wired panel from Stein Air. I feel like I am too deep to look back now. Eddie did you run your CHT sensor wire to the probe? The drawing has me to believe the CHT probe is grounded next to the probe itself on the engine, but I dont see why I can't ground the sensor at the ground bus bar coming from the GEA-24?
Re: Garmin G3x Wiring Questions
Hey Dustin, I couldn't offer any advice because the 912iS has all that stuff wired already. I just had to get a "pig tail" harness to bridge from the engine harness to the ECU. I only had one sensor to wire and that was the fuel flow sensor. Sorry I couldn't help. I get it, I would wire my own stuff if I do it again. I don't much care for the fit of my harnesses.
Re: Garmin G3x Wiring Questions
Next question is the audio from the G3x. Is the mono for warnings and stereo for music? I am guessing I should hook up both just trying to understand what each one is for?
Re: Garmin G3x Wiring Questions
Quote:
Next question is the audio from the G3x. Is the mono for warnings and stereo for music? I am guessing I should hook up both just trying to understand what each one is for?
Don't over think this part, but I think you are correct. Just hook the audio up as depicted.
Re: Garmin G3x Wiring Questions
Quote:
Originally Posted by
PapuaPilot
Don't over think this part, but I think you are correct. Just hook the audio up as depicted.
Thanks. Trying not to....
Is there a good help line for garmin? I am guessing I better program that number in my phone!