Rotax 912 Fuel Pump Overpressure
Hello,
I have about 20 hours on one of the new style "Corona" fuel pumps.
Yesterday while returning home on a cross country the fuel pressure started drifting. 7, down to 4, up to 7, 8 ,9,10,8,7... All very slow. 10,12,11,13,...eventually I saw 20.
If the pressure went low I have an electric pump inline but nothing I can do about overpressure. The engine didn't miss a beat and the fuel flow meter stayed constant. I tried clearing the engine a few times without much change.
Of course I'm thinking instrumentation so before ordering anything I'll need to put another pressure meter on a T and run it on the ground to see. If it all holds steady at 7PSI like it has all along I'm not sure what to think.
Has anyone heard of a similar problem with the new pump? Or old one for that matter. I'll call Lockwood on Monday and ask the same.
Thanks in advance,
Mark Napier
Re: Rotax 912 Fuel Pump Overpressure
Had a similar problem and it turned out to be instrumentation, good call to check that first.
Re: Rotax 912 Fuel Pump Overpressure
I have also heard of people needing to add a pressure regulator...
Re: Rotax 912 Fuel Pump Overpressure
I would have thought that if the higher fuel pressures were correct you would have had issues with rough running of the engine as the carb float needle valves would have been overpowered and cause the carbs to flood?
Re: Rotax 912 Fuel Pump Overpressure
What Dave said makes sense. If those pressures were real, I don't think the engine would run smoothly and normal.
Re: Rotax 912 Fuel Pump Overpressure
Isn't a fuel return line kit (over pressured fuel goes back into the header tank) a good solution to over pressure?
Skot
Re: Rotax 912 Fuel Pump Overpressure
The fuel return loop uses a small orifice, .015" diameter, to allow for a small amount of fuel to flow keeping vapor lock from happening.
This will have little effect in keeping pressure regulated.
Re: Rotax 912 Fuel Pump Overpressure
Don't have the experience with the 912, but the same type of carb is used on a Jabiru engine, and at 20 PSI, I'm sure you would be flooding the engine. Bings don't want much pressure. (one of my dead stick landings and discussions with the technical advisor at Bing carb taught me this) Jim Chuk
3 Attachment(s)
Re: Rotax 912 Fuel Pump Overpressure
I have posted pix of a recent modification I made to my Model 4 Speedster under construction using an aftermarket Holley adjustable fuel regulator that should keep fuel pressure to the carbs constant. Purchased the regulator for about $26 from jegs.
Last two pix show regulator mounted to my firewall.
Tom Stuart
Re: Rotax 912 Fuel Pump Overpressure
Tom,
Which fuel pressure regulator did you go with?
Brian